Apollo 65 User Manual download pdf (Page 204)

approach. You will now return to Approach

Transition mode. The Approach Active light will

go out and the CDI will gradually go back to

Approach Transition CDI sensitivity (from 0.3 nm

to 1.0 nm full-scale).

As soon as you enable sequencing, the Apollo GX will

sequence to the next waypoint in the flight plan. This

is the next waypoint in the published missed approach

procedure.

If the next waypoint is the MAHP, it is an automatic

holding point and sequencing will again be

automatically suspended. The OBS/HOLD light will

come back on. Operation will change from Approach

Active to Approach Transition.

3. Verify or select the next waypoint in your flight

plan. If the active waypoint is not the one you wish

to navigate to, select a new active waypoint. If the

active waypoint you want is already in your active

flight plan, the easiest way to select it is to press

FPL, to enter flight plan mode. Turn the SMALL

knob until the waypoint you want is shown as the

“TO” side of a flight plan leg . Then press

DIRECT-TO and ENTER to select the waypoint.

Note

If the same waypoint appears in the

approach sequence more than once, be sure

to turn to the occurrence you wish to select.

4. If a specific inbound course to the active waypoint

is to be intercepted or flown, press

DIRECT-TO

twice.

5. Set the desired inbound course with the

LARGE and

SMALL knobs. If flying a holding pattern, press

OBS/HLD. Then, press ENTER. Selecting an

inbound course in this manner will suspend flight

plan sequencing and the

OBS/HLD annunciator will

light. See page 24 for details on holding patterns.

9-14

Approach Basics (GX50/60)

FPL

ENTER

D D

ENTER

1 2 ... 199 200 201 202 203 204 205 206 207 208 209 ... 323 324

Comments to this Manuals

No comments

Apollo 65 User Manual Page 204

Comments to this Manuals