Apollo 1600 Installation Manual download pdf (Page 16)

SYMPTOM

Gate will not open or close.

Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts and

never drop below 11 volts when gate is operating.

Reset program switches to factory setting. # 1,# 3,# 7,# 8 ON, all others OFF.

Disconnect all accessories from the circuit board - receivers, push buttons, keypads, loops, phones, intercoms, etc.

Activate the operator by momentarily shorting GND to INP

on one of the three pin connectors.

If the operator works, reconnect each accessory individually

starting with push button and test operation.

Disconnect actuator from circuit board and inspect pins in the connector for damage or

poor connections.

Check for proper limit switch configuration (multimeter required) on the connector from

the actuator:

GATE IN OPEN POSITION .......Orange & Green wires are shorted, White & Green wires

are open.

GATE IN CLOSED POSITION ..White & Green wires are shorted, Orange & Green wires are open.

GATE IN MID TRAVEL............ White, Green, & Orange wires are open, no shorts.

Replace circuit board.

1 ON

2 off

3 ON

4 off

5 off

6 off

7 ON

8 ON

9 off

RED & WHITE PROGRAM

SWITCHES

GND INP 12V

Momentarily short

with a piece of wire

or needle nose.

1 2 ... 11 12 13 14 15 16 17

No comments

Apollo 1600 Installation Manual Page 16