Apollo Radius User Manual download pdf (Page 43)

Updated 23/05/07 RAOM0507 Apollo Bicycle Company Pty. Ltd. ABN: 60 001 914 469

Cable Tension Adjustment

1. The rotor bearing unit should appear parallel to

the upper and lower cable stops once installed.

If the unit is tilted, pull each cable end one at a

time, to see which one has slack on the bearing

hook. Pick up the slack through the adjusting

barrel. When even pull on all four cables is

reached secure all four lock nuts.

2. Check for even pull on all four cables by rotating

the handlebar while the front wheel is off the

ground. If a fluttering noise is heard in the rotor

bearing unit as the upper and lower cables pass

each other, repeat the adjusting step 1.

SADDLE AND SEAT POST

Inspection

Part of your monthly maintenance tasks needs

to include inspection and adjustment of the

seat post binder bolt and the seat fixing bolt,

ensuring both are firmly secured. When the

seat post is removed from the frame, a mark

about 65mm up from the bottom can be

observed, with the words “max. height” or

“minimum insertion”. At all times a minimum

of 65mm of seat tube must always remain

in the frame.

Never ride a bicycle with the

minimum insertion/max. height mark

visible on the seat post. Doing so

may damage the seat post, the

frame or potentially even the rider.

Lubrication

Remove the seat post from the frame and

clean thoroughly. Lightly grease the part that

will be inserted into the frame. Replace the

seat post into the frame and adjust and fasten.

Adjusting Bolt

Micro Adjustable Seat Post

Seat Clamp Nut

Standard Seat Post

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 71 72

No comments

Apollo Radius User Manual Page 43